HACS and Customization

Is ESPHome better than tasmota?

Neither ESPHome nor Tasmota is better in every case. ESPHome suits Home Assistant-focused DIY builds, while Tasmota suits common plugs and MQTT setups.

On this page
  1. Quick comparison
  2. Where ESPHome fits better
  3. Where Tasmota fits better
  4. What both have in common
  5. Can you switch later?
  6. How to choose

Neither firmware is better in every case. ESPHome is usually the better fit if Home Assistant is the centre of your setup and you build your own sensors or devices. Tasmota is usually the better fit if you want to flash common plugs and switches quickly, or if your system runs on MQTT or on something other than Home Assistant.

Quick comparison

ESPHome Tasmota
Configuration A YAML file compiled into custom firmware Prebuilt firmware, set up in the web interface, console commands and templates
Making a change Recompile, then update over the air Usually no recompile for configuration changes
Home Assistant link Native API on TCP port 6053, with optional encryption, no MQTT needed MQTT with a broker, plus the Tasmota integration
Chips ESP8266, the ESP32 family, RP2040, and some others through LibreTiny ESP8266 and the ESP32 family
On-device automation On-device automations and C++ lambdas in YAML Rules on ESP8266; Berry scripting on ESP32
Use beyond Home Assistant Tightly aligned with Home Assistant Works well with openHAB, Node-RED and any MQTT setup

Where ESPHome fits better

  • You build your own sensors or devices from ESP boards and parts.
  • You want one place to manage many devices. The ESPHome Device Builder handles configuration and updates.
  • You want the tightest Home Assistant link. ESPHome connects through its own API, so you don’t need a broker.
  • You want extras such as a Bluetooth proxy, voice assistant satellites, or a large library of sensor and display components.

Where Tasmota fits better

  • You flash off-the-shelf plugs, switches or relays that Tasmota supports.
  • You want to configure a device from a web page without building firmware.
  • Your system is MQTT-based, or it is not Home Assistant. Tasmota works well with openHAB, Node-RED and similar tools.
  • You want on-device rules or scripts. Rules run on ESP8266, and Berry scripting runs on ESP32.

What both have in common

  • Neither runs on every cheap or Tuya chip. Check your chip before you buy. Local control in Home Assistant explains which Tuya chips can’t run Tasmota.
  • Flash is tight on 1 MB ESP8266 devices. Both fit, but there is little room for over-the-air updates.
  • Compiling takes time. ESPHome compiles need a reasonable CPU. A first build on a Raspberry Pi can take several minutes.
  • Flashing mains devices is dangerous. Never flash a device while it is connected to mains power.

Can you switch later?

Often, yes. ESPHome can be flashed from Tasmota’s upgrade page with a .bin file, though size limits apply. Check the firmware size first, because a large ESPHome build may not fit.

How to choose

Ask yourself three questions:

  1. What is the device or chip? If it is a Tuya or other cheap chip, check that it runs either firmware before you buy.
  2. Is Home Assistant the centre of the setup? If yes, ESPHome is usually the simpler path.
  3. Do you already use MQTT? If yes, Tasmota fits in easily.

If you choose ESPHome, the setup guide takes you from the add-on install to your first adopted device. ESPHome doesn’t need MQTT, so you can skip the broker setup described in do you need MQTT for Home Assistant?.

The complete guide to hacs and customization

What Is HACS and How to Install It in Home Assistant
Read the guide

Keep exploring

Guides from other topics

All topics →